ok. I am struggling to find information. I have a herms system with a separate vessel for my hot water/heat exchanger. In that vessel i have a bucket heater on a unistat iia temp controller. My temps hit 155 all the time just fine and hold well.
Now, I'd like to ditch the heat exchange vessel and use my HLT as a heat source. I can do a few things.
1. I can cycle my pump on and off with the temp controller. This would work but I'd like to circulate continuously because my mind tells me that is better for some reason.
2. I can put a solenoid valve in line so that it opens and closes with the temp controller sending water to the heat exchanger as needed. ????
My first choice is number 2, but I have no idea how to wire up a solenoid valve. I know they make 110V valves. Can I just put a plug on it and plug it into my temp controller? I have zilcho electrical skills and figure that it can't be that easy. I see all of these PID dealios and have no desire to go that route unless it can be done on the 3rd grade level, which is where I am. HELP!