mash tun geometry
Posted: Thu Jun 23, 2005 11:43 am
by brewmasterjjfad
Just picked up a 30 gallon stainless pot. 17" diameter 4' tall. What is the rule of thumb for height to width ratio for a mash tun.
Posted: Thu Jun 23, 2005 12:13 pm
by Lufah
Not sure how much this helps, but check here....
Tun Geometry and Flow Potential
http://www.howtobrew.com/appendices/appendixD-2.html
Travis
Re: mash tun geometry
Posted: Thu Jun 23, 2005 1:47 pm
by dazed
brewmasterjjfad wrote: 17" diameter 4' tall.
Thats A NICE
Pot!
Posted: Fri Jun 24, 2005 1:30 am
by Triple Freak
Where did you find a pot like that?
Re: mash tun geometry
Posted: Fri Jun 24, 2005 1:46 pm
by Bugeater
brewmasterjjfad wrote:Just picked up a 30 gallon stainless pot. 17" diameter 4' tall. What is the rule of thumb for height to width ratio for a mash tun.
You sure about those measurements? That works out to just over 47 gallons.