Kewler Kitz

[bluelou6]

The comments on the MoreBeer website say the Kewler Kitz is for Rubbermaid/Gott coolers. Has anyone had any problems using it in an Igloo?

[Steelers&Beer]

if you check northern brewer, they have bulkhead fittings for the igloo coolers. i use one in my 54 qt extreme cooler...works great. later, Drew

[BeerPal]

if you check northern brewer, they have bulkhead fittings for the igloo coolers. i use one in my 54 qt extreme cooler...works great. later, Drew

+1

Same here

[stumblemonk]

Not sure about you guys, but I think I used the XL kit for my Coleman Extreme cooler. I think it was specificaly recommended for that one.

I had a lot of problems with the interior o-ring. It kept getting pushed into the hole and leaking rather badly. Eventually I took it out and just have the metal washer snugged against the cooler wall and it's been lek-free ever since.

[foomench]

I have an Igloo Ice Cube and found the Kewler Kitz did not work because the cooler wall wasn't thick enough where I intended to install it. I bought the keg version instead and it worked fine. What Igloo do you have?

[bluelou6]

I have the round, orange 10 gallon.