SAYING HI ! NEW TO BN FROM WEST LINN OREGON

[Brian2078]

I have been brewing all-Grain for about a year now and i am starting to build a brutus ten system.
any sugestions on the type of burners i should use?
i was thinking of going with the 10 inch banjo low pressure burners

[Kbar]

Hello from LO. Check into PDX Brewers. We meet once a month. Love to see you there. Name is Brian K.

Good luck on the single tier setup!

[andy77]

I've had the banjo burners since I started brewing outside. First on a turkey fryer setup then on a Blichmann Top Tier. I've never had any complaints. Great burners that heat evenly and fast.

[captain carrot]

Welcome to the Asylum! Good luck on your Brutus build!

[triple-oh-six]

Welcome brotha!
I have 3 banjo burners that replaced my jet burners after way too many problems.
I love them.
Prost!

[snowcapt]

Welcome to the show. Sure sounds like you know what you are doing.
Carry on.

[Brian2078]

Thanks for the invite i will check out PDX Brewers soon!

as for the brutus ten systems i am still collecting parts but i am getting close
i went with the 3 10' banjo burners

I did just buy a barleuy crusher grain mill and lots of grain i was tired of getting difffrent efficiency from diffrent stores mills
now i can controll my crush less variables less problems right
i must say after a little over a year i love brewing beer