Double Seal
Posted: Wed Apr 28, 2010 4:11 pm
by Garrete
Does anyone know the number for the double seals that The Pope was talking about for the kegs?
I went to McMaster-Carr.com but was not able to find the rings The Pope was talking about.
Thank you in advance.
Re: Double Seal
Posted: Wed Apr 28, 2010 4:20 pm
by JohnF
Re: Double Seal
Posted: Wed Apr 28, 2010 4:50 pm
by Garrete
JohnF wrote:http://www.mcmaster.com/#90025k368/=6v2z69
HOLY CRAP!
Thanks! I saw that, but did not think that is what it was.
DUH! I is a gooderer learner!
Re: Double Seal
Posted: Wed Apr 28, 2010 4:56 pm
by JohnF
Yeah, double seal = quad cross section.
I was calling them "square cross section" in another thread which is something entirely different (surprisingly enough, a square cross section - I guess that math degree failed me).
Re: Double Seal
Posted: Sat May 01, 2010 9:24 am
by jamilz
I always used to call them "quad rings" and nobody new what I was talking about. I found out most people were calling them double-seal. McM calls them quad.
Try them, you'll be amazed at how well they seal. You can put your posts on finger tight, then just gently snug them down with a wrench until it stops. Don't use a bunch of force.