Chiller question

[Brew Engineer]

Nope, it wont work for you at all. But, if you have it sent to me, I'll "modify" it for you, so it will work with your set-up.




Congrats you lucky stinking bastard...

[BayouBrew]

Nope, it wont work for you at all. But, if you have it sent to me, I'll "modify" it for you, so it will work with your set-up.




Congrats you lucky stinking bastard...

That won't work either. No modification can help you. I will volunteer to dispose of it for you.
j/k. Congrats and enjoy.

[Mylo]

about modifying my dip tube, can I just buy a short piece of flexible copper tube and bend it around the inner idameter of the keg?

I'm thinking I've heard that it's nearly impossible to find bendable copper tubing in short pieces so if that's the case, can I just fashion one up using my trusty torch, solder and several different angle bend pieces?

All you need is a 1/2" pipe thread fitting (M or F to suit your system) to 1/2" copper, 1 - 90* elbow, and a 4-6" piece of ridgid 1/2" copper pipe.


Mylo

[San_Diego_Matt]

will you entertain me with pictures Mylo?

[Mylo]

will you entertain me with pictures Mylo?

I suppose I can return the favor, but I doubt you will find it as entertaining as I find your avatar...



Full thread here: viewtopic.php?f=4&t=13341


Mylo