Beer Forum

I'm looking for an automatic vlave for my brewstand and i was wondering if this would work to control the gas going to the HLT and Mash Tun

Valve,Solenoid,1/2 In
Solenoid Valve, Number of Ways 2, Normally Closed, Pipe Size 1/2 In, Orifice Dia 5/8 In, 150 PSI Differential Air Inert Gas, 150 PSI Differential Water, Max. Flow Rate 49.0 GPM, Coefficient of Volume 4.00, 180, Voltage 120, Watts 10.1, Coil Insulation Class F, Coil Enclosure Molded Epoxy, Body Material Brass

Brand RED HAT
Mfr. Model # 8210G094

Number of Ways 2
Configuration Normally Closed
Pipe Size (In.) 1/2
Orifice Dia. (In.) 5/8
PSI Differential Min. 0
PSI Differential Air Inert Gas 150
PSI Differential Water 150
Max. Flow GPM 49.0
Coefficient of Volume 4.00
Max. Fluid Temp. (F) 180
Voltage 120
Watts 10.1
Coil Insulation Class F
Coil Enclosure Molded Epoxy
Body Material Brass
Construction Reference No. 10

I'd call B3 and talk to Chris Gram.

I would say yes, however, since they explicitly list "Inert Gas" this tells you no! After a little research it looks like you need a #8210G075


See this PDF http://www.ascovalve.com/Common/PDFFiles/Product/8210_NC.pdf