Beer Forum

This is a forum for enlisted and new recruits of the BN Army. Home brewers bringing it strong! Learn how to brew beer, trade secrets, or talk trash about your friends.
http://www.thebrewingnetwork.com/forum/

How much PBW would it take in my beer to make it undrinkable

http://www.thebrewingnetwork.com/forum/viewtopic.php?f=19&t=18261

Page 1 of 2

How much PBW would it take in my beer to make it undrinkable

Posted: Wed Dec 16, 2009 9:35 am
by Henway
Dumb mistake. Cooled the beer down to ferment temp, then put on blow off tube from my corny into maybe 600mL excess PBW (I usually use StarSan but didn't have any made up). The next day I see all the PBW sucked into the corny. Grrrrrrr. The PBW was mixed to 12Tbs/5 Gal strength. I drank a little of the post-ferment beer--the FG is the same as the other half of it in the fermenter and it tastes mostly the same (though I was experimenting with all Nottingham in one and a mix of yeast in the other) I've only drunk the contents of the hydrometer tube. It could be my imagination, but 10 minutes after drinking my mouth feels a little drier than usual. But that could be my imagination. Advice?

Re: How much PBW would it take in my beer to make it undrinkable

Posted: Wed Dec 16, 2009 9:45 am
by Grist Licker
Well it probably won't hurt you, but I would toss it...unless it tastes really good, then drink it! Can this really be the worse you've put in your body?

Re: How much PBW would it take in my beer to make it undrinkable

Posted: Wed Dec 16, 2009 9:45 am
by Grist Licker
Oh, and sorry that's probably no help.

Re: How much PBW would it take in my beer to make it undrinkable

Posted: Wed Dec 16, 2009 10:48 am
by bcmaui
PBW CAN BE HARMFUL IF SWALLOWED! See page 2 of the safety sheet.

http://www.fivestarchemicals.com/tech/pbw.pdf

Toss it.

Star San foam is OK, diluted PBW is not.

Re: How much PBW would it take in my beer to make it undrinkable

Posted: Wed Dec 16, 2009 6:35 pm
by Henway
damn..............

Re: How much PBW would it take in my beer to make it undrinkable

Posted: Wed Dec 16, 2009 6:40 pm
by jwatkins56550
why did you make it so strong? 12 tablespoons per 5 gallons is a lot!

Re: How much PBW would it take in my beer to make it undrinkable

Posted: Wed Dec 16, 2009 7:31 pm
by AndrewD
Did he died?

Re: How much PBW would it take in my beer to make it undrinkable

Posted: Wed Dec 16, 2009 7:46 pm
by Henway
Ummmm following the directions? It says to have 12T per 5 gallons.....

All times are UTC - 8 hours
Page 1 of 2