SAYING HI ! NEW TO BN FROM WEST LINN OREGON
Posted: Thu Sep 01, 2011 2:44 pm
by Brian2078
I have been brewing all-Grain for about a year now and i am starting to build a brutus ten system.
any sugestions on the type of burners i should use?
i was thinking of going with the 10 inch banjo low pressure burners
Re: SAYING HI ! NEW TO BN FROM WEST LINN OREGON
Posted: Fri Sep 02, 2011 9:28 pm
by Kbar
Hello from LO. Check into PDX Brewers. We meet once a month. Love to see you there. Name is Brian K.
Good luck on the single tier setup!
Re: SAYING HI ! NEW TO BN FROM WEST LINN OREGON
Posted: Fri Sep 02, 2011 10:55 pm
by andy77
I've had the banjo burners since I started brewing outside. First on a turkey fryer setup then on a Blichmann Top Tier. I've never had any complaints. Great burners that heat evenly and fast.
Re: SAYING HI ! NEW TO BN FROM WEST LINN OREGON
Posted: Sat Sep 03, 2011 6:39 am
by captain carrot
Welcome to the Asylum! Good luck on your Brutus build!
Re: SAYING HI ! NEW TO BN FROM WEST LINN OREGON
Posted: Sat Sep 03, 2011 9:23 pm
by triple-oh-six
Welcome brotha!
I have 3 banjo burners that replaced my jet burners after way too many problems.
I love them.
Prost!
Re: SAYING HI ! NEW TO BN FROM WEST LINN OREGON
Posted: Sun Sep 04, 2011 4:51 am
by snowcapt
Welcome to the show. Sure sounds like you know what you are doing.
Carry on.
Re: SAYING HI ! NEW TO BN FROM WEST LINN OREGON
Posted: Thu Oct 27, 2011 12:00 pm
by Brian2078
Thanks for the invite i will check out PDX Brewers soon!
as for the brutus ten systems i am still collecting parts but i am getting close
i went with the 3 10' banjo burners
I did just buy a barleuy crusher grain mill and lots of grain i was tired of getting difffrent efficiency from diffrent stores mills
now i can controll my crush less variables less problems right
i must say after a little over a year i love brewing beer