It is currently Sun Sep 14, 2014 8:00 pm

All times are UTC - 8 hours





Post new topic Reply to topic  [ 2 posts ] 
Author Message
 Post subject: Partial Mash - How much
PostPosted: Fri Oct 01, 2010 8:50 pm 
 Profile

Joined: Sat Jan 30, 2010 8:27 pm
Posts: 52
Is there a suggested or preferred amount of base malt for a partial mash recipe ?

I'm basically following the stove top mashing covered in Brewing Classic Styles. And I'm also using BeerSmith software - which typically pops in a pound of base malt if you use the recipe wizard to convert from extract to partial mash.

I typically use a pound to a pound and a half -- and I'm still doing a partial boil of 3.6gal


Top
 

 Post subject: Re: Partial Mash - How much
PostPosted: Sat Oct 02, 2010 9:04 am 
Global Moderator
User avatar
 WWW  Profile

Joined: Thu Jun 03, 2010 2:09 pm
Posts: 4581
Location: Ohio
Medals: 2
Drunk of the Week (2)
If you need to be hitting a particular post mash wort volume for your boil, you should be able to back calculate how much grain you can use. If you are shooting for 3.6, you would be using slightly more (since your grain will soak some up). Assuming a batch sparge (which is essentially what BCS's two pot method is), if you use 4 gal total (I think that some grains will likely retain more water than others, someone else may have a better idea on this), you could use 2.25 for mash and 1.75 for sparge (others feel free to chime in with better numbers). Using 2.25gal for mash will give you 9 quarts. If you assume a grain to water ratio of 1:1.5 (again, can vary), that will mean you would use 6lbs of grain. Out of those six pounds, subtract out your specialty grains and make up the balance with base male.

You also need to take into account the size of your available pots... if your second pot is small, you might not have room for that much grain and would be better off doing a smaller partial mash and adding water to bring you up to your 3.6gal volume. This is the case for me, I've been using the bottling bucket as one of my pots, adding my strike water to that and then doing my sparge by dunking the bag in the brew pot.

_________________
Spiderwrangler
PFC, Arachnid Deployment Division

In the cellar:
In the fermentor: Belgian Cider
In the works: Wooden Cider


Top
 

Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 8 hours



Who is online

Users browsing this forum: No registered users


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  

Powered by phpBB © 2009 phpBB Group